Birinchi qadam - ramkani ochish, frezalashtirgichni qo'yish va frezani ramkaga mahkamlash uchun qulflash tugmachasini burish. Nasos stantsiyasini ishga tushirganda, yo'nalishni boshqarish dastagi neytral holatda bo'lganda amalga oshirilishi kerak va yuqori bosim ostida ishga tushirish qat'iyan man etiladi.
Ikkinchi bosqichda frezalashtirgich ishga tushiriladi, armatura yopiladi va quvur moslamasining oxirgi yuzi kesiladi.
The third step is to remove the milling cutter, close the fixture, and check the gap at both ends of the tube (the gap should not be greater than 0.3mm). When removing the milling cutter from the frame, avoid the collision between the milling cutter and the end face. If it has occurred, it needs to be re-milled; the milled end face should not be touched by hand or contaminated by oil.
To'rtinchi qadam - isitish plitasini olib tashlash va tezda ikkita issiq erigan so'nggi yuzlarni bir-biriga yopishtirish va bosim o'tkazish. Sifatli termoyadroviyni ta'minlash uchun kommutatsiya davri qanchalik qisqa bo'lsa, shuncha yaxshi bo'ladi.
5-qadam, sovib turing va kuting
